Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Next revision Both sides next revision
bootloader:openocd [2021/01/30 17:32]
admin 		bootloader:openocd [2021/01/30 17:33]
admin
Line 1: Line 1:
-====== OpenOCD with the Raspberry Pi ======+====== OpenOCD & Raspberry Pi ======
  
 {{:bootloader:swd-raspi_programmer_seeeduinoxiao.jpg?400|}}\\ {{:bootloader:swd-raspi_programmer_seeeduinoxiao.jpg?400|}}\\
Line 10: Line 10:
   $ git clone http://openocd.zylin.com/openocd   $ git clone http://openocd.zylin.com/openocd
   $ cd openocd/   $ cd openocd/
-Configure & install:+Configure & Install:
   $ ./bootstrap    $ ./bootstrap 
   $ ./configure --enable-sysfsgpio --enable-bcm2835gpio   $ ./configure --enable-sysfsgpio --enable-bcm2835gpio
   $ make   $ make
   $ sudo make install   $ sudo make install
-Check  list of interfaces:+Check  Interfaces:
   $ cd /usr/local/share/openocd/scripts/interface/   $ cd /usr/local/share/openocd/scripts/interface/
   $ ls   $ ls
-Make a folder:+New Folder:
   $ cd ~   $ cd ~
   $ mkdir bootloader   $ mkdir bootloader
   $ cd bootloader   $ cd bootloader
-Download the bootloader:+Download the Bootloader:
   $ wget https://github.com/arduino/ArduinoCore-samd/raw/master/bootloaders/zero/samd21_sam_ba.bin   $ wget https://github.com/arduino/ArduinoCore-samd/raw/master/bootloaders/zero/samd21_sam_ba.bin
   $ wget https://github.com/Seeed-Studio/ArduinoCore-samd/blob/master/bootloaders/XIAOM0/bootloader-XIAO_m0-v3.7.0-33-g90ff611-dirty.bin   $ wget https://github.com/Seeed-Studio/ArduinoCore-samd/blob/master/bootloaders/XIAOM0/bootloader-XIAO_m0-v3.7.0-33-g90ff611-dirty.bin
   $ wget "https://github.com/arduino/ArduinoCore-samd/blob/master/bootloaders/mkrzero/samd21_sam_ba_arduino_mkrzero.hex"   $ wget "https://github.com/arduino/ArduinoCore-samd/blob/master/bootloaders/mkrzero/samd21_sam_ba_arduino_mkrzero.hex"
-Make your config file:+Make your Config File:
   $ nano openocd.cfg   $ nano openocd.cfg
 Add: Add: