Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision Next revision Both sides next revision | ||
cnc:froehliche_wissenschaft [2019/01/03 18:31] admin created |
cnc:froehliche_wissenschaft [2020/02/14 16:43] admin [Hardware] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ===== Froehliche | + | ===== Die Fröhliche |
{{: | {{: | ||
- | A CNC controll system for the installation | + | |
- | It's based on a Raspberry Pi that controls an Arduino with three stepper motors and two gear motors. An other Arduino is for the chalk control.\\ | + | The installation |
+ | |||
+ | It's based on a Python program that runs on a Raspberry Pi that controls an Arduino with three stepper motors and two gear motors.\\ | ||
+ | An other Arduino is for the chalk control.\\ | ||
+ | |||
+ | All controlling systems, the hard - and software was designed and made by Wolfgang Spahn 2014.\\ | ||
---- | ---- | ||
==== Software ==== | ==== Software ==== | ||
+ | |||
+ | Here is the code for a CNC control system of the installation: | ||
* {{ : | * {{ : | ||
* {{ : | * {{ : | ||
Line 12: | Line 19: | ||
* {{ : | * {{ : | ||
* {{ : | * {{ : | ||
+ | |||
+ | {{: | ||
+ | |||
+ | ==== Hardware ==== | ||
+ | |||
+ | The controlling is done with:\\ | ||
+ | * a [[https:// | ||
+ | * a [[https:// | ||
+ | * three [[https:// | ||
---- | ---- |