Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
cnc:froehliche_wissenschaft [2020/02/14 15:00] admin [Froehliche Wissenschaft] |
cnc:froehliche_wissenschaft [2020/02/14 16:37] admin [Die Fröhliche Wissenschaft] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ===== Froehliche | + | ===== Die Fröhliche |
{{: | {{: | ||
- | A CNC controll system for the installation " | ||
+ | The installation [[http:// | ||
- | It's based on a Python program that runs on a Raspberry Pi that controls an Arduino with three stepper motors and two gear motors. An other Arduino is for the chalk control.\\ | + | It's based on a Python program that runs on a Raspberry Pi that controls an Arduino with three stepper motors and two gear motors.\\ |
+ | An other Arduino is for the chalk control.\\ | ||
+ | |||
+ | All controlling systems, the hard - and software was designed and made by Wolfgang Spahn 2014.\\ | ||
---- | ---- |