Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
esp32:esp32_main [2018/02/23 14:47] admin [WeMos ESP32 OLED Board] |
esp32:esp32_main [2020/11/17 15:40] admin [DAC] |
||
---|---|---|---|
Line 2: | Line 2: | ||
[[https:// | [[https:// | ||
+ | |||
+ | [[https:// | ||
+ | |||
[[https:// | [[https:// | ||
+ | |||
{{: | {{: | ||
+ | |||
+ | ---- | ||
+ | ===== Serial to USB Driver ===== | ||
+ | |||
+ | - [[https:// | ||
+ | - [[https:// | ||
---- | ---- | ||
Line 16: | Line 26: | ||
</ | </ | ||
- | === Upload a Scetch | + | === Upload a Sketch |
The Examples for the ESP32 become visible after selecting **ESP32 DEV MODULE** in the Arduino IDE.\\ | The Examples for the ESP32 become visible after selecting **ESP32 DEV MODULE** in the Arduino IDE.\\ | ||
- | Set the flashing speed to 460800 or lower.\\ | + | Set the flashing speed to 460800 or lower (115200).\\ |
- | Upload your scetch.\\ | + | Upload your sketch.\\ |
It could be necessary to start the IDE with administrator rights, too.\\ | It could be necessary to start the IDE with administrator rights, too.\\ | ||
+ | |||
+ | ---- | ||
+ | === Special Hardware Configuration ==== | ||
+ | |||
+ | ** The I/O pins are not 5V-tolerant! **\\ | ||
+ | Use 3.3V instead.\\ | ||
+ | \\ | ||
+ | The build in LED is on GPIO 2.\\ | ||
+ | \\ | ||
+ | GPIO 34, 35, 36, 37, 38 and 39 are input only. And don't have a software pull-up or pull-down functions. One has to use an external 10k pull-up resistor.\\ | ||
+ | \\ | ||
+ | GPIO 6, 7, 8, 9, 10 and 11 are used for the SPI flash chip and can't be used for any other purposes.\\ | ||
---- | ---- | ||
Line 26: | Line 48: | ||
{{: | {{: | ||
- | The OLED is connected | + | The OLED is connected |
+ | | ||
+ | pin4 - SCL | ||
The I2C address of the screen is 0x3c.\\ | The I2C address of the screen is 0x3c.\\ | ||
+ | #include " | ||
+ | SSD1306 | ||
Librarie:\\ | Librarie:\\ | ||
Line 82: | Line 107: | ||
---- | ---- | ||
+ | ==== Adafruit HUZZAH32 – ESP32 Feather Board ==== | ||
+ | |||
+ | [[https:// | ||
+ | [[https:// | ||
+ | |||
+ | ---- | ||
+ | ===== DAC and ADC ===== | ||
+ | |||
+ | **DAC**\\ | ||
+ | The ESP32 has two DAC pins, GPIO25 and GPIO26. The resolution is 8 bits.\\ | ||
+ | | ||
+ | |||
+ | ---- | ||
+ |