Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
raspberry:videolooper [2021/05/31 21:22] admin [Software] |
raspberry:videolooper [2021/06/07 16:35] admin [SSH over USB] |
||
|---|---|---|---|
| Line 61: | Line 61: | ||
| + | |||
| + | ---- | ||
| + | ==== USB OTG ==== | ||
| + | |||
| + | To power the Pi and at the same time connect an USB hub to it with just a single USB cable one needs an USB OtG cable. An other way would be to solder a 100k resistor between the sense pin P40 and the ground pin P6 on the Raspberry Pi. That way every USB cable act as an OTG cable. | ||
| + | |||
| + | |||
| + | ---- | ||
| + | ==== SSH over USB==== | ||
| + | |||
| + | [[raspberry: | ||
| ---- | ---- | ||