Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
raspberry:videolooper [2021/06/07 16:35] admin [SSH over USB] |
raspberry:videolooper [2021/06/07 18:07] admin [Read Only] |
||
---|---|---|---|
Line 63: | Line 63: | ||
---- | ---- | ||
- | ==== USB OTG ==== | + | ==== all in one USB cable ==== |
- | To power the Pi and at the same time connect an USB hub to it with just a single USB cable one needs an USB OtG cable. An other way would be to solder a 100k resistor between the sense pin P40 and the ground pin P6 on the Raspberry Pi. That way every USB cable act as an OTG cable. | + | To power and simultaneously |
+ | |||
+ | An other possibility would be this [[raspberry: | ||
+ | |||
+ | {{: | ||
---- | ---- | ||
Line 76: | Line 80: | ||
===== Read Only ===== | ===== Read Only ===== | ||
For preventing any data loss while turning off the Pi one has to change the SD card to read only: [[raspberry: | For preventing any data loss while turning off the Pi one has to change the SD card to read only: [[raspberry: | ||
+ | |||
+ | ---- | ||
+ | ==== License ==== | ||
+ | |||
+ | This manuals is made by **Wolfgang Spahn** 2021.\\ | ||
+ | Except where otherwise noted, content on this wiki is licensed under the following license: [[http:// | ||
+ | |||
+ | < | ||
+ | <a rel=" | ||
+ | </ | ||
---- | ---- |