Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
raspberry:videolooper [2021/06/07 17:10] admin [USB OTG] |
raspberry:videolooper [2021/06/07 18:07] (current) admin [Read Only] |
||
---|---|---|---|
Line 64: | Line 64: | ||
---- | ---- | ||
==== all in one USB cable ==== | ==== all in one USB cable ==== | ||
- | |||
- | USB On-The-Go (OTG) for Zero\\ | ||
To power and simultaneously connect an USB hub to the Raspberry Pi Zero with just a single USB cable one needs an [[https:// | To power and simultaneously connect an USB hub to the Raspberry Pi Zero with just a single USB cable one needs an [[https:// | ||
- | An other possibility would be to solder a wire between the USB sense pin P40 (of USB J10) and the ground pin P6 on the Raspberry Pi. That way every USB cable on the USB socket J10 (not "Power In") act like an OTG cable.\\ | ||
+ | |||
+ | An other possibility would be this [[raspberry: | ||
+ | |||
+ | {{: | ||
---- | ---- | ||
Line 79: | Line 80: | ||
===== Read Only ===== | ===== Read Only ===== | ||
For preventing any data loss while turning off the Pi one has to change the SD card to read only: [[raspberry: | For preventing any data loss while turning off the Pi one has to change the SD card to read only: [[raspberry: | ||
+ | |||
+ | ---- | ||
+ | ==== License ==== | ||
+ | |||
+ | This manuals is made by **Wolfgang Spahn** 2021.\\ | ||
+ | Except where otherwise noted, content on this wiki is licensed under the following license: [[http:// | ||
+ | |||
+ | < | ||
+ | <a rel=" | ||
+ | </ | ||
---- | ---- |