Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
raspberry:zero_over_usb [2020/02/26 22:23] admin |
raspberry:zero_over_usb [2021/05/31 22:55] (current) admin [on Arch Linux] |
||
---|---|---|---|
Line 2: | Line 2: | ||
This is a manual for connecting a Raspberry Pi Zero to your computer via USB. | This is a manual for connecting a Raspberry Pi Zero to your computer via USB. | ||
- | After burning the image on your SD card one has to add the USB driver on startup. | + | After burning the image on your SD card one has to add the USB driver on startup. |
+ | |||
+ | Enable SSH on the Raspberry Pi in:\\ | ||
+ | $ sudo raspi-config | ||
+ | or create a new file named " | ||
+ | |||
+ | To change the DesignWare Core to 2 write in / | ||
dtoverlay=dwc2 | dtoverlay=dwc2 | ||
- | and in / | + | and in / |
modules-load=dwc2, | modules-load=dwc2, | ||
- | Create a new file named " | + | |
- | \\ | + | |
Connect the Pi Zero with an USB cable or an [[https:// | Connect the Pi Zero with an USB cable or an [[https:// | ||
$ ssh pi@raspberrypi.local | $ ssh pi@raspberrypi.local | ||
Line 19: | Line 24: | ||
$ sudo pacman -S avahi nss-mdns | $ sudo pacman -S avahi nss-mdns | ||
Start the avahi-daemon.service | Start the avahi-daemon.service | ||
- | $ systemctl start avahi-daemon.service | + | |
+ | $ sudo systemctl start avahi-daemon.service | ||
Edit the edit the file / | Edit the edit the file / | ||
$ sudo nano / | $ sudo nano / | ||
Line 30: | Line 36: | ||
in IPv4: " | in IPv4: " | ||
in IPv6: " | in IPv6: " | ||
+ | \\ | ||
+ | Activate the network connection: | ||
+ | | ||
---- | ---- |