Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
seeeduino:seeeduino_xiao [2020/12/28 17:08] admin |
seeeduino:seeeduino_xiao [2020/12/28 23:16] admin [Reset & Bootloader Mode] |
||
---|---|---|---|
Line 3: | Line 3: | ||
{{: | {{: | ||
- | The [[https:// | + | The [[https:// |
[[https:// | [[https:// | ||
**All I/O Pins are 3.3V** | **All I/O Pins are 3.3V** | ||
+ | |||
+ | To use the DAC and the PWM follow the manual of the | ||
+ | [[http:// | ||
+ | |||
+ | ---- | ||
+ | ==== Installation ==== | ||
+ | |||
+ | To add Seeeduino XIAO to Arduino IDE add in file/ | ||
+ | https:// | ||
+ | Than search and install in tools/ | ||
+ | Seeed SAMD Boards | ||
+ | |||
+ | On Arch Linux it needs always two attempts to upload the code, the / | ||
---- | ---- | ||
==== Pinout ==== | ==== Pinout ==== | ||
+ | {{: | ||
+ | |||
+ | TX - pin 06 | ||
+ | RX - pin 07 | ||
+ | DAC - pin 00 | ||
+ | Build In LED - 13 | ||
{{: | {{: | ||
- | //pinout by [[https:// | + | // |
- | + | ||
- | {{: | + | |
---- | ---- | ||
==== Reset & Bootloader Mode ==== | ==== Reset & Bootloader Mode ==== | ||
- | {{: | + | {{: |
- | To reset the board one should | + | To reset the board one should |
- | And to enter the bootloader mode one should | + | And to enter the bootloader mode one should |
---- | ---- | ||
==== Serial Wire Debug (SWD) ==== | ==== Serial Wire Debug (SWD) ==== | ||
{{: | {{: | ||
+ | |||
+ | ---- | ||
+ | ==== Miscellaneous === | ||
+ | [[https:// | ||
+ | |||
+ | [[https:// | ||
+ | |||
+ | ---- | ||
+ | ==== License ==== | ||
+ | |||
+ | This manuals is made by **Wolfgang Spahn** 2020.\\ | ||
+ | Except where otherwise noted, content on this wiki is licensed under the following license: [[http:// | ||
+ | |||
+ | < | ||
+ | <a rel=" | ||
+ | </ | ||
---- | ---- | ||