Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
analogcomputation:01_chuascircuit [2020/05/21 20:01] admin [Build] |
analogcomputation:01_chuascircuit [2020/05/21 20:07] admin [Build] |
||
|---|---|---|---|
| Line 42: | Line 42: | ||
| === Power Supply === | === Power Supply === | ||
| - | Additionally one needs a power supply. To get the positive and the negative 9V the easiest way is to use two 9V batteries…\\ | + | One needs a power supply, too. To get the positive and the negative 9V to power the Confetti boards |
| [[https:// | [[https:// | ||
| [[https:// | [[https:// | ||
| - | === ... and some Caps === | + | === ... and some Caps and a Poti === |
| - | To build a Chua's Circuit out of these board one needs additionally a breadboard, some jumper wires, | + | To build a Chua's Circuit out of these board one needs additionally a breadboard |
| * **Capacitors: | * **Capacitors: | ||
| * 1x 100 nF | * 1x 100 nF | ||
| * 1x 10 nF | * 1x 10 nF | ||
| - | * **Mechanical: | ||
| - | * 2x 9V battery clip | ||
| - | * 2x 3 pin strip (for the battery connector) | ||
| * **Potentiometers: | * **Potentiometers: | ||
| * 1x 5 kOhm | * 1x 5 kOhm | ||
| - | And for attaching the circuit to an audio mixer one should use an additional high Ohm resistor. Something like 500 KOhm should do. | + | === Audio Out === |
| + | |||
| + | For attaching the circuit to an audio mixer one should use an additional high Ohm resistor. Something like 500 KOhm should do.\\ | ||
| + | A much better way would be to use a buffered audio output.\\ | ||
| + | [[https:// | ||
| + | [[https:// | ||
| ---- | ---- | ||