Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
bootloader:openocd [2021/01/30 17:39] admin [OpenOCD & Raspberry Pi] |
bootloader:openocd [2021/01/30 17:58] (current) admin [Acknowledge & Links] |
||
---|---|---|---|
Line 3: | Line 3: | ||
{{: | {{: | ||
- | On a Raspberry Pi following the openOCD | + | To install the [[http:// |
Install: | Install: | ||
Line 65: | Line 65: | ||
$ sudo nano / | $ sudo nano / | ||
$ sudo nano / | $ sudo nano / | ||
+ | Change: | ||
+ | # Each of the SWD lines need a gpio number set: swclk swdio | ||
+ | # Header pin numbers: 23 22 | ||
+ | bcm2835gpio_swd_nums 25 24 | ||
+ | |||
+ | # If you define trst or srst, use appropriate reset_config | ||
+ | # Header pin numbers: TRST - 26, SRST - 18 | ||
+ | bcm2835gpio_trst_num 7 | ||
+ | bcm2835gpio_srst_num 18 | ||
---- | ---- | ||
- | ==== HEX files ===== | + | ==== Bootloader |
- [[https:// | - [[https:// | ||
Line 75: | Line 84: | ||
---- | ---- | ||
==== Pinout ==== | ==== Pinout ==== | ||
+ | |||
+ | SWD | ||
+ | | ||
+ | | ||
+ | | ||
+ | | ||
**Arduino MKR ZERO**\\ | **Arduino MKR ZERO**\\ | ||
Line 100: | Line 115: | ||
==== Acknowledge & Links ==== | ==== Acknowledge & Links ==== | ||
+ | [[http:// | ||
+ | [[http:// | ||
[[https:// | [[https:// | ||
+ | [[https:// | ||
---- | ---- |