Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision Next revision Both sides next revision | ||
cnc:froehliche_wissenschaft [2019/01/03 18:31] admin created |
cnc:froehliche_wissenschaft [2019/01/03 18:36] admin |
||
---|---|---|---|
Line 2: | Line 2: | ||
{{: | {{: | ||
- | A CNC controll system for the installation " | + | A CNC controll system for the installation "[[http:// |
It's based on a Raspberry Pi that controls an Arduino with three stepper motors and two gear motors. An other Arduino is for the chalk control.\\ | It's based on a Raspberry Pi that controls an Arduino with three stepper motors and two gear motors. An other Arduino is for the chalk control.\\ | ||
Line 13: | Line 13: | ||
* {{ : | * {{ : | ||
+ | {{: | ||
---- | ---- |