Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
cnc:froehliche_wissenschaft [2019/01/03 18:33]
admin [Froehliche Wissenschaft] 		cnc:froehliche_wissenschaft [2019/01/03 18:36]
admin
Line 4: Line 4:
 A CNC controll system for the installation "[[http://anklam-henninger.de/|Fröhliche Wissenschaft]]" by Thomas Henninger and Axel Anklam in cooperation with Wolfgang Spahn at the federal ministry of education and research in Berlin, 2014.\\ A CNC controll system for the installation "[[http://anklam-henninger.de/|Fröhliche Wissenschaft]]" by Thomas Henninger and Axel Anklam in cooperation with Wolfgang Spahn at the federal ministry of education and research in Berlin, 2014.\\
 It's based on a Raspberry Pi that controls an Arduino with three stepper motors and two gear motors. An other Arduino is for the chalk control.\\ It's based on a Raspberry Pi that controls an Arduino with three stepper motors and two gear motors. An other Arduino is for the chalk control.\\
-{{:cnc:froehlichwissenschaft_aufbau_02.jpg?300|}}\\ 
  
 ---- ----
Line 14: Line 13:
    * {{ :cnc:manual.zip |}}    * {{ :cnc:manual.zip |}}
  
 +{{:cnc:froehlichwissenschaft_aufbau_02.jpg?400|}}\\
 ---- ----