Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Next revision Both sides next revision
cnc:froehliche_wissenschaft [2019/01/03 18:33]
admin [Froehliche Wissenschaft] 		cnc:froehliche_wissenschaft [2019/01/03 18:37]
admin [Froehliche Wissenschaft]
Line 3: Line 3:
 {{:cnc:froehlichwissenschaft_aufbau_01.jpg?600|}}\\ {{:cnc:froehlichwissenschaft_aufbau_01.jpg?600|}}\\
 A CNC controll system for the installation "[[http://anklam-henninger.de/|Fröhliche Wissenschaft]]" by Thomas Henninger and Axel Anklam in cooperation with Wolfgang Spahn at the federal ministry of education and research in Berlin, 2014.\\ A CNC controll system for the installation "[[http://anklam-henninger.de/|Fröhliche Wissenschaft]]" by Thomas Henninger and Axel Anklam in cooperation with Wolfgang Spahn at the federal ministry of education and research in Berlin, 2014.\\
-It's based on a Raspberry Pi that controls an Arduino with three stepper motors and two gear motors. An other Arduino is for the chalk control.\\ + 
-{{:cnc:froehlichwissenschaft_aufbau_02.jpg?300|}}\\+ 
 +It's based on a Python program that runs on a Raspberry Pi that controls an Arduino with three stepper motors and two gear motors. An other Arduino is for the chalk control.\\
  
 ---- ----
Line 14: Line 15:
    * {{ :cnc:manual.zip |}}    * {{ :cnc:manual.zip |}}
  
 +{{:cnc:froehlichwissenschaft_aufbau_02.jpg?400|}}\\
 ---- ----