Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
cnc:froehliche_wissenschaft [2020/02/14 16:43] admin [Hardware] |
cnc:froehliche_wissenschaft [2020/02/14 16:59] admin [License] |
||
---|---|---|---|
Line 5: | Line 5: | ||
The installation [[http:// | The installation [[http:// | ||
- | It's based on a Python program that runs on a Raspberry Pi that controls | + | It' |
- | An other Arduino is for the chalk control.\\ | + | The controlling system is based on a Python program that runs on a Raspberry Pi that controls |
+ | An other Arduino is for the chalk control. The chalk control is activated with a Reed Relais.\\ | ||
All controlling systems, the hard - and software was designed and made by Wolfgang Spahn 2014.\\ | All controlling systems, the hard - and software was designed and made by Wolfgang Spahn 2014.\\ | ||
Line 26: | Line 27: | ||
The controlling is done with:\\ | The controlling is done with:\\ | ||
* a [[https:// | * a [[https:// | ||
+ | * an [[https:// | ||
+ | and the following Paper Boards:\\ | ||
* a [[https:// | * a [[https:// | ||
* three [[https:// | * three [[https:// | ||
+ | * two [[https:// | ||
+ | |||
+ | |||
+ | ---- | ||
+ | ==== License ==== | ||
+ | |||
+ | The Paper Duino Pim the Motor Control Board and the Stepper-Motor-Board are designed by **Wolfgang Spahn** 2012-14\\ | ||
+ | \\ | ||
+ | All programs are written by **Wolfgang Spahn** 2014.\\ | ||
+ | \\ | ||
+ | They are licensed under a [[http:// | ||
+ | |||
+ | < | ||
+ | <a rel=" | ||
+ | </ | ||
---- | ---- |