Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
esp32:esp32_main [2018/02/23 14:36] admin [Espressif ESP32 Development Board] |
esp32:esp32_main [2020/10/13 19:43] admin [Espressif ESP32 Development Board] |
||
---|---|---|---|
Line 2: | Line 2: | ||
[[https:// | [[https:// | ||
+ | |||
+ | [[https:// | ||
+ | |||
[[https:// | [[https:// | ||
+ | |||
{{: | {{: | ||
+ | |||
+ | ---- | ||
+ | ===== Serial to USB Driver ===== | ||
+ | |||
+ | - [[https:// | ||
+ | - [[https:// | ||
---- | ---- | ||
Line 16: | Line 26: | ||
</ | </ | ||
- | === Upload a Scetch | + | === Upload a Sketch |
The Examples for the ESP32 become visible after selecting **ESP32 DEV MODULE** in the Arduino IDE.\\ | The Examples for the ESP32 become visible after selecting **ESP32 DEV MODULE** in the Arduino IDE.\\ | ||
- | Set the flashing speed to 460800 or lower.\\ | + | Set the flashing speed to 460800 or lower (115200).\\ |
- | Upload your scetch.\\ | + | Upload your sketch.\\ |
It could be necessary to start the IDE with administrator rights, too.\\ | It could be necessary to start the IDE with administrator rights, too.\\ | ||
+ | |||
+ | The build in LED is on Pin 2.\\ | ||
+ | Pin 34 and 35 don't work.\\ | ||
---- | ---- | ||
Line 26: | Line 39: | ||
{{: | {{: | ||
- | The OLED is connected | + | The OLED is connected |
+ | | ||
+ | pin4 - SCL | ||
+ | The I2C address of the screen is 0x3c.\\ | ||
+ | #include " | ||
+ | SSD1306 | ||
Librarie:\\ | Librarie:\\ | ||
[[https:// | [[https:// | ||
Board: | Board: | ||
+ | Manuals:\\ | ||
[[http:// | [[http:// | ||
+ | [[https:// | ||
---- | ---- | ||
Line 78: | Line 98: | ||
---- | ---- | ||
+ | ==== Adafruit HUZZAH32 – ESP32 Feather Board ==== | ||
+ | |||
+ | [[https:// | ||
+ | [[https:// | ||
+ | ---- | ||
+ |