This is an old revision of the document!
Table of Contents
STM32duino - Blue Pill F103C8
The STM32duino board is based on the ARM Cortex M3 core like the Arduino Duo. The version I use is the Blus Pill.
On Hackaday is a good article about STM32 clones: STM32-Clones - the good the bad and the ugly.
USB Fix
Unfortunately the board comes with a 10k pullup resistor from D+ to 3.3V (in the schematic it's a 4.7k). That can cause problems on some PCs. Just take the R10 out and replace it with an 1.5k resistor like shown here:
http://wiki.stm32duino.com/index.php?title=Blue_Pill#Hardware_installation
One might let the 10k resister untouched and just put a 1.8k in parallel. Between 3.3V and pin A1 (PA12).
And here are some useful infos about the pullup resistors on USB:
https://www.beyondlogic.org/usbnutshell/usb2.shtml
Schematic
Specification
Model: STM32F103C8T6 Core: ARM 32 Cortex-M3 CPU Debug mode: SWD 72MHz work frequency 64K flash memory 20K SRAM 2.0-3.6V power, I/O Reset(POR/PDR) 8MHz crystal LED on pin PC13
Software
Here is an installation guide here:
http://wiki.stm32duino.com/index.php?title=Installation
and here:
https://github.com/rogerclarkmelbourne/Arduino_STM32/wiki/Installation
Uploading a sketch:
http://wiki.stm32duino.com/index.php?title=Uploading_a_sketch
Debugging with GDB by Hackaday:
https://youtu.be/D-MbC9N5U7o
Links
License
This manuals is made by Wolfgang Spahn 2018-20.
It is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.