Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
analogcomputation:01_chuascircuit [2020/05/20 22:23] admin |
analogcomputation:01_chuascircuit [2020/05/21 19:53] admin [Buy the Parts] |
||
---|---|---|---|
Line 11: | Line 11: | ||
The circuit basically just needs 5 parts:\\ | The circuit basically just needs 5 parts:\\ | ||
- | {{: | ||
- | //[[https:// | + | [[https:// |
+ | // | ||
C1 = 10 nF\\ | C1 = 10 nF\\ | ||
Line 54: | Line 54: | ||
==== Schematic ==== | ==== Schematic ==== | ||
- | {{: | + | {{: |
---- | ---- | ||
Line 66: | Line 66: | ||
Additionally one needs some double sided tape to stick the paper printout on the [[https:// | Additionally one needs some double sided tape to stick the paper printout on the [[https:// | ||
+ | |||
+ | It is also possible to replace the [[http:// | ||
---- | ---- | ||
Line 71: | Line 73: | ||
One can connect an audio mixer (with a 500 kOhm resister) and oscilloscope probes to three different points. X and Y are at the connection of the capasitor and the poti. The third one (Z) is on the gyrator board.\\ | One can connect an audio mixer (with a 500 kOhm resister) and oscilloscope probes to three different points. X and Y are at the connection of the capasitor and the poti. The third one (Z) is on the gyrator board.\\ | ||
+ | |||
+ | {{: | ||
An oscilloscope in X-Y mode should look like that:\\ | An oscilloscope in X-Y mode should look like that:\\ |