Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
analogcomputation:01_chuascircuit [2020/05/21 19:58] admin [Build] |
analogcomputation:01_chuascircuit [2020/05/22 12:05] admin [License] |
||
---|---|---|---|
Line 30: | Line 30: | ||
One can build a Chua's Circuit with the analog computer [[https:// | One can build a Chua's Circuit with the analog computer [[https:// | ||
- | [[https:// | + | === Chua's Diode === |
+ | [[https:// | ||
[[https:// | [[https:// | ||
- | |||
- | [[https:// | ||
- | [[https:// | ||
There are different ways to implenent a Chu's Diode, an alternative Chua's Diode one finds here:\\ | There are different ways to implenent a Chu's Diode, an alternative Chua's Diode one finds here:\\ | ||
[[https:// | [[https:// | ||
- | Additionally one needs a power supply. To get the positive and the negative 9V the easiest way is to use two 9V batteries…\\ | + | === Gyrator === |
- | [[https:// | + | [[https:// |
+ | [[https:// | ||
+ | |||
+ | === Power Supply === | ||
+ | One needs a power supply, too. To get the positive and the negative 9V to power the Confetti boards | ||
+ | [[https:// | ||
[[https:// | [[https:// | ||
- | To build a Chua's Circuit out of these board one needs additionally a breadboard, some jumper wires, | + | === ... and some Caps and a Poti === |
+ | |||
+ | To build a Chua's Circuit out of these board one needs additionally a breadboard | ||
* **Capacitors: | * **Capacitors: | ||
* 1x 100 nF | * 1x 100 nF | ||
* 1x 10 nF | * 1x 10 nF | ||
- | * **Mechanical: | ||
- | * 2x 9V battery clip | ||
- | * 2x 3 pin strip (for the battery connector) | ||
* **Potentiometers: | * **Potentiometers: | ||
* 1x 5 kOhm | * 1x 5 kOhm | ||
- | And for attaching the circuit to an audio mixer one should use an additional high Ohm resistor. Something like 500 KOhm should do. | + | === Audio Out === |
+ | |||
+ | For attaching the circuit to an audio mixer one should use an additional high Ohm resistor. Something like 500 KOhm should do.\\ | ||
+ | A much better way would be to use a buffered audio output.\\ | ||
+ | [[https:// | ||
+ | [[https:// | ||
+ | |||
+ | === Setup === | ||
+ | A final setup could look like that:\\ | ||
+ | {{: | ||
---- | ---- | ||
Line 105: | Line 116: | ||
==== License ==== | ==== License ==== | ||
- | The tutorial and all boards are made by **Wolfgang Spahn** 2016-20.\\ | + | Except where otherwise noted, the tutorial and all boards are made by **Wolfgang Spahn** 2016-20.\\ |
They are licensed under a [[http:// | They are licensed under a [[http:// | ||