Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
esp32:esp32_main [2018/04/17 19:34] admin [Espressif ESP32] |
esp32:esp32_main [2020/10/13 19:52] admin [Espressif ESP32 Development Board] |
||
---|---|---|---|
Line 8: | Line 8: | ||
{{: | {{: | ||
+ | |||
+ | ---- | ||
+ | ===== Serial to USB Driver ===== | ||
+ | |||
+ | - [[https:// | ||
+ | - [[https:// | ||
---- | ---- | ||
Line 20: | Line 26: | ||
</ | </ | ||
- | === Upload a Scetch | + | === Upload a Sketch |
The Examples for the ESP32 become visible after selecting **ESP32 DEV MODULE** in the Arduino IDE.\\ | The Examples for the ESP32 become visible after selecting **ESP32 DEV MODULE** in the Arduino IDE.\\ | ||
- | Set the flashing speed to 460800 or lower.\\ | + | Set the flashing speed to 460800 or lower (115200).\\ |
- | Upload your scetch.\\ | + | Upload your sketch.\\ |
It could be necessary to start the IDE with administrator rights, too.\\ | It could be necessary to start the IDE with administrator rights, too.\\ | ||
+ | |||
+ | ---- | ||
+ | === Special Hardware Configuration ==== | ||
+ | |||
+ | ** The I/O pins are not 5V-tolerant! ** Use 3.3V instead.\\ | ||
+ | The build in LED is on Pin 2.\\ | ||
+ | Pin 34 - 39 are input only. And don't have a software pull-up or pull-down functions. One has to use an external 10k pull-up resistor. Details are at | ||
+ | [[https:// | ||
---- | ---- | ||
Line 89: | Line 103: | ||
---- | ---- | ||
+ | ==== Adafruit HUZZAH32 – ESP32 Feather Board ==== | ||
+ | |||
+ | [[https:// | ||
+ | [[https:// | ||
+ | ---- | ||
+ |