Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
frames:bottom_plate_arduino [2017/04/07 21:30] admin |
frames:bottom_plate_arduino [2020/05/12 16:49] (current) admin [License] |
||
---|---|---|---|
Line 1: | Line 1: | ||
===== Bottom Plate for Arduino ===== | ===== Bottom Plate for Arduino ===== | ||
+ | {{: | ||
Here is a bottom plate for the Arduino, the holes are made for a 2.5M 4mm screw.\\ | Here is a bottom plate for the Arduino, the holes are made for a 2.5M 4mm screw.\\ | ||
Line 8: | Line 9: | ||
---- | ---- | ||
+ | ==== License ==== | ||
+ | |||
+ | That 3D-object was designed by **Wolfgang Spahn** 2016.\\ | ||
+ | It is licensed under a [[http:// | ||
+ | |||
+ | < | ||
+ | <a rel=" | ||
+ | </ | ||
+ | |||
+ | ---- | ||
+ |