Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
raspberry:videolooper [2021/05/27 16:03] admin [Software] |
raspberry:videolooper [2021/06/07 18:07] (current) admin [Read Only] |
||
---|---|---|---|
Line 21: | Line 21: | ||
$ ssh pi@ 192.168.??? | $ ssh pi@ 192.168.??? | ||
on the Pi update and upgrade: | on the Pi update and upgrade: | ||
- | $ sudo apt update | + | $ sudo apt-get update |
- | $ sudo apt upgrade | + | $ sudo apt-get upgrade |
Install the omxplayer: | Install the omxplayer: | ||
- | $ sudo apt install omxplayer | + | $ sudo apt-get install omxplayer |
=== Autostart === | === Autostart === | ||
+ | To create the autostart open: | ||
+ | $ sudo nano / | ||
+ | and write before "exit 0" the following: | ||
+ | printf " | ||
+ | printf " | ||
+ | printf " | ||
+ | printf " | ||
+ | printf " | ||
+ | printf " | ||
+ | printf " | ||
+ | printf " \n" | ||
+ | |||
+ | If one wants to run an additional program these line should be added: | ||
+ | # start LEDs blinking | ||
+ | printf "start to blink an LED on GPIO 27\n" | ||
+ | / | ||
+ | e.g.: | ||
+ | $ wget http:// | ||
+ | $ tar xf blink_02.py.tar | ||
+ | $ sudo chown root:root blink_02.py | ||
+ | $ sudo chmod 755 blink_02.py | ||
+ | |||
+ | And to start the omxplayer add that: | ||
+ | # start the omxplayer | ||
+ | printf "start the video loop\n" | ||
+ | omxplayer / | ||
+ | |||
+ | To run the omxplayer in the background one has to add the "&" | ||
+ | |||
+ | Copy the video to / | ||
+ | |||
+ | |||
+ | |||
+ | ---- | ||
+ | ==== all in one USB cable ==== | ||
+ | |||
+ | To power and simultaneously connect an USB hub to the Raspberry Pi Zero with just a single USB cable one needs an [[https:// | ||
+ | |||
+ | |||
+ | An other possibility would be this [[raspberry: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | ---- | ||
+ | ==== SSH over USB==== | ||
+ | |||
+ | [[raspberry: | ||
+ | |||
+ | ---- | ||
===== Read Only ===== | ===== Read Only ===== | ||
For preventing any data loss while turning off the Pi one has to change the SD card to read only: [[raspberry: | For preventing any data loss while turning off the Pi one has to change the SD card to read only: [[raspberry: | ||
+ | |||
+ | ---- | ||
+ | ==== License ==== | ||
+ | |||
+ | This manuals is made by **Wolfgang Spahn** 2021.\\ | ||
+ | Except where otherwise noted, content on this wiki is licensed under the following license: [[http:// | ||
+ | |||
+ | < | ||
+ | <a rel=" | ||
+ | </ | ||
---- | ---- |