Pi Zero always On-The-Go
a USB-OTG Hack
If one needs to connect different devices to a Raspberry Pi Zero but want's to use just one USB port one can use an USB On-The-Go (OTG) cable.
This USB mod was developed for the Real Existing Tokke for the artwork:
Patagonian Pattern\
These USB adapter normally come with an USB socket, but if one needs an other connector the easiest solution would be to bridge the “OTG” pin to ground on the Pi Zero board itself.
This small hack goes like that: solder a wire between the USB sense pin PP40 (of USB J10) and the ground pin PP6 on the Raspberry Pi. That way every USB cable on the USB socket J10 (not “Power In”) act like an OTG cable.
The work was realized with support of Stiftung Kunstfonds, Sonderförderprogramm 20/21 - NEUSTART KULTUR.
License
This manuals is made by Wolfgang Spahn 2021.
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
