Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Last revision Both sides next revision
raspberry:videolooper [2021/05/27 16:03]
admin [Software] 		raspberry:videolooper [2021/06/07 17:53]
admin [all in one USB cable]
Line 21: Line 21:
  $ ssh pi@ 192.168.???.????  $ ssh pi@ 192.168.???.????
 on the Pi update and upgrade: on the Pi update and upgrade:
-  $ sudo apt update +  $ sudo apt-get update 
-  $ sudo apt upgrade+  $ sudo apt-get upgrade
 Install the omxplayer: Install the omxplayer:
-  $ sudo apt install omxplayer+  $ sudo apt-get install omxplayer
  
 === Autostart === === Autostart ===
  
 +To create the autostart open:
 +  $ sudo nano /etc/rc.local
  
 +and write before "exit 0" the following:
 +  printf "  \n"
 +  printf "    =============================================\n"
 +  printf "    =             MY VIDEO LOOP                 =\n"
 +  printf "    =                                           =\n"
 +  printf "    =          wolfgang spahn 01-2021           =\n"
 +  printf "    =         http://dernulleffekt.de           =\n"
 +  printf "    =============================================\n"
 +  printf " \n"
 +
 +If one wants to run an additional program these line should be added:
 +  # start LEDs blinking
 +  printf "start to blink an LED on GPIO 27\n"
 +  /home/pi/python/blink_02.py &
 +e.g.:
 +   $ wget http://www.dernulleffekt.de/programme/blink_02.py.tar
 +   $ tar xf blink_02.py.tar
 +   $ sudo chown root:root blink_02.py
 +   $ sudo chmod 755 blink_02.py
 +
 +And to start the omxplayer add that:
 +  # start the omxplayer
 +  printf "start the video loop\n"
 +  omxplayer /home/pi/video/myvideo.mp4 &
 +
 +To run the omxplayer in the background one has to add the "&" at the end of the line.\\
 +
 +Copy the video to /home/pi/video. It should be has to be an mp4 (H264) format.\\
 +
 +
 +
 +----
 +==== all in one USB cable ====
 +
 +To power and simultaneously connect an USB hub to the Raspberry Pi Zero with just a single USB cable one needs an [[https://en.wikipedia.org/wiki/USB_On-The-Go|USB-OTG]] cable.\\
 +
 +
 +An other possibility would be this [[raspberry:pi_zero_usb-otg|Pi Zero USB-OTG Hack]].\\
 +
 +{{:raspberry:usb-osg_on_zero_01.jpg?400|}}\\
 +
 +----
 +==== SSH over USB====
 +
 +[[raspberry:zero_over_usb|Connect a Raspberry Pi Zero over USB]]
 +
 +----
 ===== Read Only ===== ===== Read Only =====
 For preventing any data loss while turning off the Pi one has to change the SD card to read only: [[raspberry:read_only|Read-Only SD Card]] For preventing any data loss while turning off the Pi one has to change the SD card to read only: [[raspberry:read_only|Read-Only SD Card]]
  
 ---- ----